1. After ingestion, CDL works in the body for up to 1.5 hours and then breaks down into water, salt and oxygen .
2. The effect is based on oxidation . Electron exchange kills bacteria, viruses and small and single-celled parasites. Their reproduction is also prevented.
3. During oxidation, CDL also renders heavy metals harmless in the body.
4. The pathogens and heavy metals mentioned are responsible for around 95% of all diseases .
5. In addition, the pathogens – including mutated virus or bacterial strains – do not become resistant to it.
6. The decay products water, table salt and oxygen are simply excreted . Taking it does not cause poisoning, side effects or deposits in the body.

(This is just a theoretical explanation)

This is CDL and this is how it works.

For legal reasons we have to distance ourselves from the internal application of CDL. The theoretical explanation listed here is for your information only.

The effect of CDL.

After ingestion, CDL works in the body for up to an hour and a half and then breaks down into water, salt and oxygen. The effect is based on oxidation. Through an exchange of electrons, bacteria, viruses and small and single-celled parasites are killed and their reproduction is also prevented.

Multicellular, larger parasites such as taenia (tapeworms), ascarids (roundworms) and yeast fungi can be decimated by CDL. As a rule, however, they cannot be eradicated through application.

During oxidation (burning), CDL also renders heavy metals harmless in the body.

The above-mentioned pathogens and heavy metals are responsible for around 95% of all diseases, which is why the positive effect of CDL should not be underestimated.

CDL has a very low redox potential of only 0.9 volts. Therefore, when used correctly, it does not attack the intestinal flora or other body tissue. There is no addictive potential.

In addition, pathogens - including mutated virus or bacterial strains - do not become resistant to it. Since the decay products water, table salt and oxygen are simply excreted, ingestion does not cause poisoning, side effects or deposits in the body. In the worst case, the most damaging effect could be the lack of effect.


Interesting facts about the raw material chlorine dioxide.

We all know chlorine dioxide as an effective and environmentally friendly disinfectant solution. It is used in the sanitary sector, in water treatment and in surface and vessel disinfection. Even drinking water contains small amounts of CLO₂.

Its oxidizing power is very high, it removes biofilms and has a constant bactericidal effect. The effect starts after just a few minutes and is easy to use. The level of disinfection is:
99.99999%.

Further possible applications:

✅ For a full bath, we add approx. 100 drops of chlorine dioxide solution to warm bath water at approx. 37 degrees and bathe in it for approx. 20 minutes.

✅ For a partial bath we add approx. 50 drops of chlorine dioxide solution to 1 liter of water.

In our CDL set you will receive the following components from us:

✅ 20 ml sodium chlorite 22.4%

✅ 20 ml hydrochloric acid 10%

✅ 20 ml DMSO 99.99%

✅ 20 ml lactic acid 80% LMQ

✅ 2 pieces 20 ml syringes

✅ 2 pieces 80 mm cannulas

✅ 1 piece of manufacturing instructions (as a link to a PDF file)

Important information:

• HS Activa assumes no liability for effects and possible undesirable effects when using CD / CDL / CDS.
• It is normal for pure DMSO to solidify at an ambient temperature of 19 degrees and below . If you place the bottle in a room with a temperature of 22 degrees or higher or in a warm water bath, it will become liquid again.
• Contents: Each bottle contains 20 ml. This corresponds to approximately 300 drops. With 1 drop per application there would be 300 glasses.
• Potency: For a glass with 100 ml of water, in which 1 drop each of the hydrochloric acid and the sodium chlorite are activated and converted as a gas, the result is a potency of 9-12 PPM.